Motorola Minitor 5/V Compatible Belt Clip Repair Part

The belt clip release latch on the Motorola Minitor 5/V pager is known to break really easily. I decided to fix that.
1
31
1
460
updated March 1, 2022

Description

PDF

The belt clip release latch on the Motorola Minitor 5/V pager is known to break really easily. I decided to model the part that breaks, so as long as you have the belt clip, spring, and rod, you can repair it without needing to buy a whole new clip. It works pretty well on my unit, it fits snugly and latches in very tight.

You will most likely need to use a screwdriver to pry the tab forward if you want to remove it from the pager. This model is pretty close to the original, however, when docking the pager into the charger you will need to give the belt clip a bit of an extra squeeze to make sure it catches the ledge in the charger so it stays seated properly.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.16

Infill:

100%

Filament: Hatchbox PLA Black


Notes:

Hotend: 210C
Bed: 60C (Used painters tape for good grip)

Sliced in PrusaSlicer with these settings changed from defaults:

  • Support on Build Plate Only
  • Print Settings>Support Material>Pattern Spacing: 1mm
  • Print Settings>Support Material>Interface Pattern Spacing: 0.15mm
  • Don't Support Bridges: Disabled

Category: Hobby

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License