PTFE tube holder / passthrough for MMU or AMS and tent style enclosures

The holder is mainly supported by the pole in the back. 

Inner and outer plates are screwed together with M3 screws. I used 6 M3 Inserts, 4 long and two short.

Pole can be clamped down using two M3 screws, pole diameter is 7.7mm and hole diameter is 8mm. Five PC4-M10 ptfe fittings used to hold tubes in place.

Fabric can be pierced by small sharp object like a drill and screws and tubes pushed through after, no need to cut huge hole.