HeroMe Gen 7 mount for Carthographer3D eddy current sensor

A mount for the Carthographer3D ABL eddy current sensor on the HeroMe Gen7 printhead assembly.

Derived from the "generc skirt" + ADXL345 sensor mount of the HerMe Gen 7.4

!! This is not tested - I did not receive my Carthographer3D yet !!!

Print orientation has been optimized to minimize support.

Cartghographer3D https://cartographer3d.com/

Print Settings

Rafts:

No

Supports:

Yes

Resolution:

0.14 - 0.28

Infill:

45

Filament Material:

ABS

Notes:

I printed this in ABS (Geeetech ABS+) like all my HeroMe parts.

For all HeroMe parts, I use

• outer layer height: 0.14mm
• inner layer height (inner perimeters and infill). 0.28mm
• line width 0.6mm
• 45% infill (not really needed here though)
• adaptive cubic infill
• automatic tree support with lean trees, on buildplate only, "only critical" NOT checked

and two postprocessing scripts in OrcaSlicer 2.3.0

• https://github.com/TengerTechnologies/Smoothificator

• https://github.com/TengerTechnologies/Bricklayers

  in this version:

  https://github.com/TengerTechnologies/Bricklayers/blob/main/NonPlanarInterlockingWalls.py

  settings see file "settings.zip"

The .3MF is for OrcaSlicer 2.3.0, the _generic.3mf is exported from OrcaSlicer als "Generic 3MF", whatever that means.

The STEP file is created by imprting the 3MF into FreeCAD 1.0 and then coverted from the mesh to a solid and exported as "STEP with colors", the FCStd file is the FreeCAD file from that conversion.

STL is exported from OrcaSlicer. Go for the 3MF if possible.

How I Designed This

Just a few modifications in OrcaSlicer ("add part" / "add negative part").