1/4" Hose Barb Fitting - "Splicer" / "Coupler"

Not recommended for high pressure or fuel applications.
Hose in photos is a 1/4" I.D. x 3/8" O.D. Clear Vinyl Tubing.
Assemble printed parts with E6000, super glue, 2-part epoxy, or similar adhesive.
Prints may need their seam scraped smooth with a knife or similar tool to ensure a good seal with each other, as well as with the hose.
Designed to print in the orientation shown in screenshots, and using the following print settings.
Designed with some room to secure hose with cable ties, if desired.

Suggested Slicer Settings:

Nozzle Size: 0.4mm
Layer Height: 0.2mm
Wall Count: 2
Infill: 100%
Brim: Outer, 5mm (or no brim, if you are confident with that)