Honeycomb Hexagonal pattern soap dish tray

This is a pair of honeycomb pattern soap dishes, one with a "natural" edge pattern and one with a smooth crisp edge. I'd seen a few other honeycomb pattern dishes online but most of them seemed to have sharp edges or would print in ways that are likely to leave stringing so I did this cleaner-looking design. You can adjust the length, width and height as well as the wall thickness and cell size by editing the OpenSCAD file in the places indicated then re-rendering and re-exporting.

It prints as a dish and 4 independent feet that should be glued into the bottom of the dish (although if you adjust the "clearance" parameter in the file properly for your printer you should be able to get them to friction-fit). The gap created under the dish by the feet should allow soapy water to drain so you don't get soggy, sticky soap.