Billfold

I wanted a flexible minimal billfold to carry some paper money around with me.

Wallet.scad modified by me to do a zero-card slot wallet or a 1 card slot wallet.

Modified from the one by jurriaanpruis on Thingiverse: https://www.thingiverse.com/thing:3348346

It replaces a previous wallet that was much larger, but where the bills kept partially sticking out and getting scuffed. This billfold fits my pocket much better, and it's easy to keep the bills well tucked in so they stay fresh. If I redo it, I'd make it even smaller.

It's in OpenSCAD so it's easy to modify further.

I'm preserving the same license as its ancestor.

Leaving the filament in a dehumidifier overnight, and printing straight from the humidifier makes it more flexible and more transparent.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

No

Supports:

No

Resolution:

0.3mm. Standard 0.4mm nozzle

Infill:

10%

Notes:

I used glue stick on the print bed as a release agent. I set it to 3 vertical perimeters, so there is no infill.

For my printer, I turn the filament-out sensor off since it is optical and clear filament confuses it.

Post-Printing

Fresh from the printer I had some minor blobbing not in the bill compartment but in the main fold. It was easy to remove with my fingers after a bit of hot air from a heat gun.