iphone5 SE cover/case - Dovetail

Iphone5 SE Dovetail cover/case. (fixed and strengthen)
reinforced models, with or without side-ring for string or chain..
different models..

These here is made in Tinkercad,
better and more precise design made with Fusion360 is found at:
https://cults3d.com/en/3d-model/gadget/iphone5-se-cover-for-impact-resistant

bottom:
The clover-leaf i used a brim inside so you only see the line and not the cut..
Pumba

Top:
Hakuna Matata
Hakuna MataTháo (girls name Tháo)

Need money for filament, so if you can & will donate a few, i will appreciate it a lot, thanks.

http://www.paypal.me/lammesky

Hope you like my work.
happy printing and good luck..!

Print instructions

Category: Mobile Phone Print Settings

Printer Brand: Prusa

Printer: i3 MK2S

Rafts: Doesn't Matter

Supports: Yes

Resolution: 0,2mm

Infill: 50-100%

Notes:

printed with flat side down for best performance..

best print is with PETG. at 100% infill at 40mms. flow95% support and brim. NoFan.
ABS and PLA works too.. (PLA is a little fragile, when you drop your phone on the floor)