TS21/C210 tips holder for IKEA Skadis (T-Clip System)
Tips holder for IKEA Skadis, allowing putting multiple side by side as your collection of tips expands
0
4
0
18
updated
September 25, 2025
Description
PDFA Miniware TS21 / C210 soldering iron tip holder for IKEA Skadis.
It uses the T-Clip locating pin variant, so it shouldn't rotate. Should be used with low profile clips.
I printed in 0.20mm PETG, others should work too. Print upright with no supports.
To install it, first put the T-clip through the clip seat on the model, then put the other side of the T-clip through the hole on your Skadis. Finally, align the part and tighten the T-Clip.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Uses T-Clip system, ideally with locating pins and low profile clips.
It's based on my parametric trays and Pinecil/TS100 tips holder.
