Pulsar Xlite V2 Dongle Holder

I use a Pulsar Xlite v2 Mini as an on the go mouse and was annoyed there wasn't a convenient place to put the dongle when not in use. So, I made a holder for the dongle. I imagine you could use this for other devices as well. 

Placement is a little finicky so I recommend using a small dab of hot glue so that you can try again easily. If placed right, the holder and dongle should not stick out at all.

Print Settings:

• Orientation - Model is preset to the right orientation
• Layer Height - 0.2mm is fine
• Material - PLA+ works great, have used PETG as well
• Infill - Shouldn't need to worry about this as the model is all vertical walls
• Support - Not necessary
• Rafts - If you don't have good bed adhesion you may want to consider a raft