Magic Band 2 Strap Keeper (Current Magicband)

Customized version of https://www.thingiverse.com/thing:2551082 I tweaked the original strap keeper to fit the…
11
89
2
630
updated February 28, 2022

Description

PDF

Customized version of https://www.thingiverse.com/thing:2551082

I tweaked the original strap keeper to fit the standard Magic Band 2. My wife lost her Magic Band during our last trip to WDW, so I made this in preparation for our next trip. Very simple design slips over the strap to make sure it stays on your wrist. I used TPU from Sain Smart on a Prusa Mk3 with the TPU config from https://github.com/eoprede/prusa_profiles/tree/master/MK3/Slic3r with excellent results.

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=2551082

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

No

Supports:

No

Resolution:

.15

Infill:

20%

Filament: Sain Smart TPU Clear


Notes:

I printed on an untreated Pei, powder coated, heated bed (60 C) without issue. Just make sure to remove before bed temp cools below 50 C... might be easier to remove with glue stick or masking tape prep. Caution: research TPU setup for your printer, it can be a pain to remove and/or clean up.

Instructions ============

Using the following options in customizer:

inner_width = 21.5

inner_height = 4

depth = 10

thickness = 1

edge_type = rounded

Category: Jewelry

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License