5VZ-FE MAF housing (1995-1998ish)

The original Denso sensor went out.  Reverse-engineered it so I could use the much more common Denso sensors from newer models that have the 5VZ-FE motor.  Fits the 1995-1999ish models, mine was made for a T100.

You need 

M6 het set inserts,

M4 heat set inserts

M4 x8mm (up to x12 should work) 

Willingness to repin your connector or get an extension. I used a URD MAF harness extension and repinned it to fit my T100.

You'll need a Denso sensor that fits, one that would go on a V6 Tacoma or 4Runner year models, something like 2000-2004.

Mine is printed out of Siraya tech fiberheart ASA GF. There's plenty of material options, but I'd say PLA or the like is a bad choice inside the engine bay for long-term survivability. The gasket is TPU, but a different flexible material should also work.