FreeTrack Cap Point Model

This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external…
0
9
0
241
updated February 28, 2022

Description

PDF

This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external power, either via USB or a battery pack. Check out the Serial Build guide on the FreeTrack forums here: http://forum.free-track.net/index.php?showtopic=1856

PointModel dimensions are 80mm side to side (40mm from centerline), 60mm up, 90mm back.

Design is based around 0.3mm layers for speed, but any layer height <=0.6mm should work fine.

Print flat, trim and assemble as needed. Put some hot glue in the corners to stiffen it up and lock everything down, then wire up.

I used some heatshrink around the LEDs to hold them in place after wiring, but hot glue would work fine - they're a pretty tight fit by hand to begin with, so they don't take much to stay stuck.

Category: Video Games

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License