Check out my new Bed Levels!
This is a test print I made to help level my bed while it's printing. It is currently made to fit a 225mm x 145mm bed, which would cover the MakerBot Replicator Dual, FlashForge Creator Pro, PowerSpec Pro 3D, etc. It helps to see if things are laying down properly, if it's more squished on one side or corner, and to make necessary adjustments.
Printer:
PowerSpec 3D Pro
Rafts:
No
Supports:
No
Notes:
Just make sure the model is as tall as a single layer at whatever height you're printing. It is by default .2mm
Category: 3D Printing TestsThe author marked this model as their own original creation. Imported from Thingiverse.