SK-Tank Carriage Strain Relief

I had a couple of extruder* wires break at the connector due to flexing while printing.

This is a small piece that provides strain relief for the wire bundle coming from the extruder/hotend on the Seckit SK-Tank. It attaches to back of the carriage, facing forward, using the top center screw hole. Then you can zip tie the wire bundle in the channel so that the wires don't move from there down.

Print Settings

Printer:

SecKit SK-Tank

Rafts:

Supports:

No

Resolution:

Infill:

40

Filament:

Blue