Ominous Industries Social Robot

More information about building this can be found here: https://github.com/OminousIndustries/SocialRobot

Here are the printing instructions for all files: 

Printer Requirements

• Build volume: Minimum 256 mm × 256 mm × 256 mm.
• Material: No special filament required—choose your preferred PLA/PETG.

Recommended Print Settings

• Layer height: 0.20 mm (use finer layers on gears/sliders for smoother motion).
• Infill: 20 % baseline (increase for structural components noted below).
• Supports: Not required unless called out.
• Orientation: All STL files are pre-oriented for printing.

Part Checklist by Folder

Use the following checklist to track prints. Notes indicate parts that benefit from finer resolution, higher infill, or support material.

Base

• Base_Plate
• Gear_Rail — finer layer height recommended for smooth motion
• Motor_Mount
• Rail_Slider — finer layer height recommended for smooth motion
• Rear_Base_Mount
• Robo_Base
• Robo_Foot — print four copies
• Ten_Tooth_Gear — print with very fine settings and small layer height

Clamps

• Rear_Projector_Clamp
• Side_Projector_Clamp — print two copies
• Top_Projector_Clamp

Head Frame

• Face_Bezel — increase infill for strength
• Front_Crossmember
• Head_Frame — print two copies; increase infill for strength
• Rear_Crossmember

Mirrors

• Rear_Mirror_Bezel
• Rear_Mirror_Bridge
• Rear_Mirror_Support
• Top_Mirror_Bezel
• Top_Mirror_Bridge

Mounts

• Front_Post_Mount
• Side_Post_Mount — print two copies

Posts

• Arduino_Mount
• Arduino_Side_Post
• Front_Post
• Jetson_Side_Post — requires supports
• Jetson_Clip — print three copiesPrinter Requirements
• Build volume: Minimum 256 mm × 256 mm × 256 mm.
• Material: No special filament required—choose your preferred PLA/PETG.

Recommended Print Settings

• Layer height: 0.20 mm (use finer layers on gears/sliders for smoother motion).
• Infill: 20 % baseline (increase for structural components noted below).
• Supports: Not required unless called out.
• Orientation: All STL files are pre-oriented for printing.

Part Checklist by Folder

Use the following checklist to track prints. Notes indicate parts that benefit from finer resolution, higher infill, or support material.

Base

• Base_Plate
• Gear_Rail — finer layer height recommended for smooth motion
• Motor_Mount
• Rail_Slider — finer layer height recommended for smooth motion
• Rear_Base_Mount
• Robo_Base
• Robo_Foot — print four copies
• Ten_Tooth_Gear — print with very fine settings and small layer height

Clamps

• Rear_Projector_Clamp
• Side_Projector_Clamp — print two copies
• Top_Projector_Clamp

Head Frame

• Face_Bezel — increase infill for strength
• Front_Crossmember
• Head_Frame — print two copies; increase infill for strength
• Rear_Crossmember

Mirrors

• Rear_Mirror_Bezel
• Rear_Mirror_Bridge
• Rear_Mirror_Support
• Top_Mirror_Bezel
• Top_Mirror_Bridge

Mounts

• Front_Post_Mount
• Side_Post_Mount — print two copies

Posts

• Arduino_Mount
• Arduino_Side_Post
• Front_Post
• Jetson_Side_Post — Requires supports (Not strict, but would benefit from a high temp material)
• Jetson_Clip — print three copies