Fan shroud ender 3 Satsana Remix

Hey there. 

I recently got in to non planar 3D-printing. Therefore I needed a bit more clearance between the nozzle and shroud. 

I liked the Satsana shroud for the Ender 3 / V2 / Pro and just edited the file for about 6 mm clearance.  (should be sufficient for most non-planar prints)

BL-touch is not supported, because the BL-Touch version does not allow remixes. 

Original file: https://www.thingiverse.com/thing:4369859 

Original for BL-Touch: https://www.prusaprinters.org/prints/58601-satsana-ender3-bltouch-fixed 

Print settings:

Nozzle: 0.4

Layers: 0.2

Supports: none 

(Make sure you can print the 45° overhangs and 16 mm bridges; line direction for bridging needs to be adjusted!)

Material: PLA (PETG, ABS, ASA, PEEK recommended)

Bed Adhesion: Brim 5 mm (outside)

Brim Distance: 0.05 mm (for better seperating)