Spool storage

So, all the storage I found did not allow for bagged spools without some grief. I wanted something simple and easy to throw spools on without the hassle of fitting it in a hole and the vacuum bag getting in the way or pierced.

You will need to get some rigid PVC tube from Amazon or the like. I used 20mm OD tube. 
This can vary a lot from manufacturer so I have put the Fusion file up so you can adjust the tube holes as required. 
Its parametric, so change the TubeOD parameter for clearance to the tube you buy. Mine was 20.3mm outer diameter so the Parameter is set to 20.4 for example.

I used 300mm lengths, if you use longer then just print another bracket and put that in the center to stop any bowing.

I printed this on a 0.4 nozzle, 3 wall loops, 0.2 layer, 20% infill for strength.