Microphone stand with spring-loaded cradle

This is a microphone holder where one side can be screwed into the mount that comes with the Behringer XM8500 microphone package, or into any other bracket with a hinge (as shown in the pictures). On the other side, there is a connection for a shock mount, which is also part of this model.

For the shock mount, you will need 4 elastic bands, 2 screws M4 × 30 mm with 2 M4 nuts, and optionally washers. Of course, you will also need the printed parts. The bends and joints are included for easier adjustment and for damping using the elastic bands, so that accidental knocks on the holder are less audible in the microphone.

Most of the parts need to be printed with supports and at least 15% infill. I printed mine in PLA, but a stronger material would be more suitable.

I hope this model will be useful for you. If it is, please share your results in the “Makes” and “Comments” sections.This is a microphone holder where one side can be screwed into the mount that comes with the Behringer XM8500 microphone package, or into any other bracket with a hinge (as shown in the pictures). On the other side, there is a connection for a shock mount, which is also part of this model.

For the shock mount, you will need 4 elastic bands, 2 screws M4 × 30 mm with 2 M4 nuts, and optionally washers. Of course, you will also need the printed parts. The bends and joints are included for easier adjustment and for damping using the elastic bands, so that accidental knocks on the holder are less audible in the microphone.

Most of the parts need to be printed with supports and at least 15% infill. I printed mine in PLA, but a stronger material would be more suitable.

I hope this model will be useful for you. If it is, please share your results in the “Makes” and “Comments” sections.

From the original model I only used the bend part, which I then modified. On one side I added a connection for a gooseneck, and on the other side I added a connection for a shock mount. The result is a complete microphone holder that combines the bend, gooseneck and shock mount.From the original model I only used the bend part, which I then modified. On one side I added a connection for a gooseneck, and on the other side I added a connection for a shock mount. The result is a complete microphone holder that combines the bend, gooseneck and shock mount.