Elegoo Centauri Carbon Ventilation Exhaust Kit

This is an exhaust kit I designed for the Elegoo Centauri Carbon to exhaust any fumes out when printing parts like ASA, ABS, etc. Included is the following

• Printer to 4" Duct Adapter
• Printer Auxillary Exhaust Cover
• 4" Duct to Fan Adapter
• Fan to Exhaust Kit Adapter

The Auxillary Exhaust Cover uses 6mm x 2mm magnets to attach to the printer, and the Printer to 4" Duct Adapter uses the existing screws on the printer. The fan is located near the Exhaust Window Kit to allow negative pressure so if there are any leaks, it is not venting to the room and is instead sucking air around the room and printer

It is designed to work with the following products linked below, but should work with any 120mm fan as long as you have the right hardware for it (M4 hardware. Length is calculated as “thickness of fan” + “8.5mm” + thickness of nut"

• 4" Duct
• Window Exhaust Kit
• 120mm Fan