Magnetic Sign Plate with Backer

Parts List:

• Decal: Amazon.com - Car Styling Decals Warning Do Not Touch Hands Window Phone DIY Sticker 150x68mm or any other 150x68mm sticker
• Magnets: TRYMAG Small 10x2mm 200Pcs Round Refrigerator Magnets, Tiny Rare Earth Mini Neodymium Multi-Use Magnets for Fridge, Whiteboard, Crafts, Dry Erase Board, Office: Amazon.com: Industrial & Scientific
  • Each hole has two magnets, so you'll need a total of 16 for a full print.
  • The brackets are design explicitly with the tolerances of stacking these linked magnets. Single 10x4mm magnets likely won't fit. 

Print Settings

• Use 0.20mm STRUCTURAL settings.
• Default 15% infill is fine.
• Any rigid plastic should work fine.
• Program a print pause at Layer 20 (just before the holes are printed over). The Magnetic Sign Print Presets 3MF attached includes this already. 

Make sure the magnets are fully seated in the holes before continuing the print!