Iphone SE phone case with integrated card holder

This is a phone case for an iPhone SE. 

An iteration of my previous model, it has push buttons and is designed to be printed with TPU. I used 95A TPU and it works pretty well. 15% cross-hatch infill worked alright but it doesn't really matter as this thing is mostly walls anyways.

There is a slot on the back to hold a single card. I designed it specifically for a card with dimensions: 54x86x1 mm. To get the card in place you slip the card under the top lip then flex the card slightly to get it under the bottom lip. A hole for your thumb allows for this process to be reversed.

Recommended to orientate it with the back of the phone case on the plate to minimise support. You will need support under the card holder section but try not to put support under the lip that holds the card as it can be very hard to get out. As per the previous model, support within the button areas shouldn't be needed and is hard to remove. Support under the side holes is recommended.

I added in a card holder slot to my original model.