Sprinkler Flag
Ran out of Sprinkler Flags, so I designed a flag that clamps on to bamboo skewers, which I had plenty of.
1
3
0
18
updated
September 18, 2025
Description
PDFThe flag is designed for the larger bamboo skewers with a ~4mm diameter.
Printed in ABS, but ASA or PETG should work as well. Note: PLA will only work in colder climates; will get soft when outside temp is too high.
The skewer is “weaved” through the 3 tabs on the flag as seen in the picture. The top tab is capped to prevent it from sliding down.
Tags
Model origin
The author marked this model as their own original creation.
