Great design.
Inside Spool Silica Gel Container (smaller holes)
Maximum diameter for the silica gel is 0.55mm. The original design had 1.5mm holes.
20
139
3
879
updated
February 28, 2022
Makes
Comments
I had some issues at first but it turns out I wasn't paying attention to slicer settings. Creator set me straight. Thanks! (edited)
@bitbanger_2643569 i printed 10+ without any issue, do you want some help?
make sure to use archne and not classic slicing, or it won't work. use auto-orient feature to place it on the flat side. obviously make sure your bed is clean af so it adheres well.
I will say that in your pic it looks as though your z-offset is incorrect i.e. the nozzle is too high but im not sure.
i also made a remix without the thermometer part. (edited)
@JayPeero_1211106 thank you for responding. I have already printed other containers but I did check out the wall generator setting and re-sliced. I didn't know the difference until now. This is very likely the cause of my issues. Thank you!
thank you for making this. all the other silica gel containers have holes that are far to large for my beads. a lot of mine are small or broken so this works great. the hygrometer spot is an extra bonus.
