Spectre Pro 23030 Fan grille with Imperial Cog

Fan grille for Bitfenix Spectre Pro 23030 fan. Slightly undersized to fit to a 200mmX200mm print bed with a bit of room for a print skirt to help with lifting. Grille is based on spacing hexagons 10mm apart. Imperial cog in the centre is 60mm diameter. The holes prepared will cover 3 sets, allowing a bit of flexibility in mounting.

The second file is larger, and will cover the entire fan, and has all of the mounting holes for the best flexibility in mounting to your case.

The third file is a plain grille, with the hexagonal pattern covering the entire area of the fan blade.

Print Settings

Printer:

MBot3D

Rafts:

No

Supports:

No

Resolution:

0.3333mm

Infill:

50%

Notes:

The larger ones are 230mm by 200mm, which is very close to the limits of my printer's range of motion. It is barely possible if the build surface is very carefully placed, and the binder clips are barely there. Your mileage my vary.

I am looking instead to have the grille laser cut from acrylic instead. This loses the variation in depth for clearing the fan blades, but I can manage that with washers instead.

Category: Computer