Makita RT0701C Pen Holder for LowRider2

The original thing has a lip around the bottom which is great for the Primo, not so much for the LowRider with the Makita clip mounted to the plate. The mount is too flexible, allowing the pen to wiggle when mounted that far from the paper.

This is meant to be used in conjunction with the original thing. The original goes "upside down" at the top of the LowRider, with the lip facing upwards. This then sits at the bottom and prevents the pen from wiggling sideways, giving 2 points of contact. This could probably also be used as a stabilizer when the mount is used with the Primo.

Print Settings

Printer:

MP3DP

Rafts:

No

Supports:

No

Resolution:

200

Infill:

38

Filament:

I cut the bottom 1mm off in TinkerCAD, and then shortened the overall height to 20mm by cutting off the top, and lowering it to that height.