FURTHER improved DJI FPV Goggles Battery Holder

The clean and beautiful original design of the headband clip for the DJI Goggles FPV battery by Rook0316_1540 couldn't prevent my battery from slipping out of the holder, even with the additional clip. Therefore, in this remix, clamps were added to the holder itself. The additional clip is no longer required.

Also, the size of the battery holder clip has been adjusted so that it fits perfectly on the back of the original DJI FPV headband.

Printing recommendation:

It is strongly recommended to print the model with PETG to give the clips the necessary flexibility when inserting the battery into the holder. The following images show suitable print orientations, with the vertical orientation resulting in a much nicer finish. If PLA is used as the printing material, the clips may break easily.

The battery is held in place without an additional clip, and the holder now fits into the centre at the back of the original headband.