Ikea Rödalm frame mount

Mounting plate for the Ikea Rödalm frame, comes with single and dual screw holes.

Only tested with the 50x40cm size frame, not sure if other size frames have the same size bracket. Designed in OpenSCAD so should be easy enough to adapt if needed.

Mount the plate with the largest surface facing away from the wall. When mounting the frame, exert a bit of pressure to the front of frame where the bracket is so the mounting bracket can slide over the plate more easily. 

To print, I doubt settings or calibration matter all that much. I printed with some leftover eSUN PLA with 3 walls and 15% infill.