Nano Pod for iFlight SucceX Whoop

Remixed the Nano Pod to accommodate the iFlight SucceX Whoop FC + vTx combo. There are cutouts along the bottom edges now to not interfere with the stack mounted vTx. There is enough room to fit a XM+ and a Runcam Nano 2.

I also added 2 2.4GHz Antenna holes and a zip tie to the fin to make mounting of all the antennas a lot cleaner.

Rigidity is the same as the original on, at least I couldn't notice a difference. Should be a little bit lighter due to the cutouts though (only .2 grams for my print).

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

1.6

Filament:

white

Notes:

Supports are only needed for the cutouts (lower 3mm of the model). I printed the model at 45mm/s on my direct drive Ender-3 Pro. Not the cleanest but took less than an hour.