35mm Handlebar Cable Guide

Design 

Slide/clip on this guide onto your 35mm handlebar to stop from cockpit cable rattle. The guide holds 1-2 cables (maybe 3?) and requires one small zip tie. I have found it especially useful in keeping cables under my race plate on my other bike. 

This is removable without cutting the zip tie for servicing and holds the cables off of the bar just enough to avoid interfering with most stems. 

Requirements 

The zip tie may be no wider than 6mm (ideally smaller) and your handlebars need to be standard 35mm diameter (most modern bikes have this). 

Recommendations 

It should work with most materials and should be printed flat with SUPPORTS ON. I printed mine from ASA with a 0.2mm layer height and 0.4mm nozzle. I manually removed some of the supports in the slicer where bridging would easily fill the gaps.