Ergo Leverless Fightstick Case v1

An Ergonomic Leverless Fightstick Case that doesn't require any print support, all parts 3d-printable.

Additional Parts needed for a fully functioning controller:

• 4 x M10 screws + nuts (printable) 
• 17 x 24mm Buttons
• 1 x 30mm Button
• 1 x Controller PCB

The bottom sides snap into the base, and the angled sides are held in place via the lid overhang.

Full print for me took ~12 hours on a Sovol SV06 Ace.

This is a v1, will likely update in the future as any issues get ironed out. But, it does work as-is.