Case for Bus Servo Driver Board

A simple snap-fit case for the seeed studio Servo Driver Board for XIAO V1.0.
No screws required — just press-fit.
Added a bottom case that mounts to the SO-101 base on September 13, 2025.

Recommended Print Settings
Material: PETG
Nozzle Diameter: 0.4mm
Layer Height: 0.2mm
Supports: 
          Not required - servo_driver_case_upper.stl, servo_driver_case_lower_plain.stl
           Please print with a brim for better bed adhesion. - servo_driver_case_lower_with_tabs.stl
Infill: 15%