Gaggia housing for PID controller and pressure gauge

This housing contains the components needed to upgrade the Gaggia Classic Pro. The housing replaces the water lid (slides down into the slot). The following are the upgrades. 

1. Mr. Shades PID controller
2. 40mm Pressure gauge
3. Pump dimmer 

There are two 3d printed parts. 

1. The housing has 4 6mm magnets inside the print near the top. You will need to pause the print, install them, and then carry on. 
2. The lid also has 4 6mm magnets. Make sure that the polarity is opposite of the housing.

I attached the Fusion 360 files so you can remove the space for magnets or change the size of the pressure gauge.

Magnets