Samsung Galaxy Watch 6 Classic (Charging Stand)

A low profile Samsung Galaxy Watch 6 Classic (Charging Stand) made and designed for my watch 6. I deigned around the “Crimson Trace Red Dot” scope profile. I looked around and saw it will fit others as well. The cutout where the charger goes into is: 29.5mm. The area where the cable goes into is only big enough to fit a (USB type-C) and will not fit a regular USB. I also put a pencil size hole in the back if the charger needs to be removed or replaced. The slot for the cable is a tight fit and was designed for a 3mm cable width that comes with the watch “OEM.” I also added 4 rubber cabinet dampener that have adhesive to stick to the bottom of the charger and greatly helps the stand from slipping around. 

I printed with PETG (recycled black) Prusament, .2mm layer height, 4 perimeters, 25% infill, paint on GRID supports and structural speed. On a Prusa MK4s 

The 3mf file is exactly what I used and was the final version.

Large v4 I made for aftermarket charger I bought from Amazon. I also designed it to get a normal USB cable through base, not just a USB-C. The charger I designed it around is: https://a.co/d/7PjPcTG

I did notice that when PLA is used the slot for the cable wire is looser and with PETG, it fits snug and as it should. Make sure to clean all the oils off plate prior to printing.

ENJOY & HAPPY PRINTING!!!!!!!!!!!!!!!!