Drippy Bucket Lid with Handle

I wanted a lid for my Drippy Bucket so I made one! 

The bucket and handle are printed separately and glued together. I printed the lid and handle at the same time at 0.2mm using Neon Green PLA from EasyPrint it took just short of 8h on my Prusa MK3S. If you decide to print the handle lying on the side as I did, I would recommend adding some small supports for the studs that will go into the lid.

NOTE: I scaled my bucket to 150% and the lid is sized to fit the increased dimensions, make sure you scale the lid to the appropriate size when slicing. (Sorry I can't give an exact number)