Ender3 S1 /Sprite zero y probe offset mount

This is a remix of tsuga's zero-Y_backplate_v2. using on my ender 3 s1 pro.  i think it should work on other printers with sprite extruder but cant say for sure. i added a rib at the top to squeeze with the lever for filament changes. it feels pretty nice. i also added a mounting spot in front of the fan to reduce flex of the backplate when squeezing filament lever.   also made the fan hole a little bigger.  other than that its pretty much the same as tsuga's. you will need to find a spare m3 screw for the additional mounting point. 

Offset X=-47mm, Y=0mm. i followed the instructions from another model on cults to adjust the printer probe offset as im still on stock firmware: With MARLIN

To change the position of the CR-Touch probe, you can modify your firmware or use gcode commands.

Download and install Pronterface and connect your printer via USB.

Then, in the terminal on the right, you should be able to use the M851 gcode, for example

M851 X-46.6 Y0

Then use M500 to save them, and M501 to set them as the active configuration.

You can check this using the M503 command.

added mounting hole for more support. added rib to squeeze against while changing filament