Dial holder for IO Mount

This is a dial holder for the IO-mount, a tool head for Two Trees CoreXY printers.

I designed this holder to pre-level the bed mechanically with a dial before the automatic meshing is executed. The holder flexes a little bit but is fine for pre-leveling. It is designed for a Mitutoyo 2046F dial which has an 8mm shaft. It is likely other dials fit as well. 

The holder gets installed with the two screws in the front of the IO mount. It is possible to just use one screw because of the free space on the back side of the holder. It is a little bit tilted when installed but does the job. The tilted position helps with rigidity as well.

I might do an angled version in the future to compensate for the tilt.

Hardware needed

• 1x bolt M3x10
• 2x bolt M3x16
• 1x thread insert M3 d=4,6mm l=5,8mm

I would be happy to see some of your makes posted :)

Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.

Link to the creator of the IO mount.

https://www.printables.com/@AndresPalomo_95968

Link to the IO mount.

https://cults3d.com/en/3d-model/tool/io-mount-a-premium-toolhead-design-for-twotrees-corexy-systems-sp-3-version