RTK Box and Tablet Holder

Here is a solution for making a DIY surveyors rod. 
Unfortunatly only the STLs exist, so I can't provide any customizations; no backup no mercy!

You need one of these telescopic rods from painting accessories. 

The antenna box part (files starting with “antenna”) is built around the components of the great ArduSimple RTK portable Bluetooth KIT. 

If you can't or don't want to use your Tablet for powering the antenna, you can use the holder to attach that round 5.000 mAh Anker power bank.

The tablet holder is designed for a Galaxy Tab S5e that sits in a silicone sleeve. Lucky you, if you have it. If not, you can try scaling the “TabClamp” files to match your devices. The holder is a simple but stable snap on solution for rods with +- 25mm diameter. 

For putting the parts together you'll need some additional parts, like M4x20 round heads and M4 threaded inserts and M6x30. 

Antenna Box:
- 9* M4x20 round head
- 9* M4 threaded inserts

Anker Holder:
- 1* M4x20 round head
- 1* M4 threaded inserts

Tablet Holder: 
- 4* M4x20 round head
- 4* M4 threaded inserts
- 1* M6x30 hex head and hex nut 

The files are already in printing position. So you'll need a lot of support, especially for the AntennaTop. If you want to reduce them, have a look at tree support through meshmixer: 
https://blog.prusaprinters.org/how-to-create-custom-overhang-supports-in-meshmixer_8188/

Files are provided as they are without any warranty. 
If you damage your devices, don't blame me.