Micron+ R1 bucket with nozzle parking and silicone brush

A mod of @KyleGB's great Micron+ Nozzle Scrubber & Purge bucket to better fit my Micron+ R1 build which includes other mods, like: 

• Blobifier
• Boop
• Z-Umbilical

The original bucket design was a bit small for my taste and i wanted the nozzle scrubber to be closer to my Blobifier. To extend the bucket to the sides, I had to account for the design of my heat plate and flex plate. 

For this mod, you'll need:

• 5x magnets (6x3mm)
• 2x heatset inserts (Voron spec: 5od x 3id x 4h)
• 9x M3x6 BHCS screws
• 4x M3 nuts to mount to the bed rails 

See the exploded CAD view for assembly guides.

For the complete setup you see in the pictures, see my other mods:

• Blobifier for Micron (shorter base, rack and pinion tray and 1515 extrusion mount)
• Micron crap catcher and Blobifier bucket for Micron+ (R1)

For sample macros to be used only with this setup, refer to the original mod's macros (and adjust accordingly). 

If you use Happy Hare in conjunction with the Blobifier addon, you'll just need to adjust parameters to indicate positions for nozzle wiping and parking.

• Enlarged bucket to go side to side, 
• Re-shaped plate to allow for the heater bed plate to have tabs to keep the brush and bucket almost touching the plate.
• Inverted the brush position to be closer to the Blobifier
• Added a nozzle park area to be filled with high-temp RTV silicone 
• Adjusted plate length to fit my bed position (with Blobifier, Boop and Z-umbilical mods)