Pica Tinny Rail to Bipod / Tripod / Shooting Sticks Adapter

My co-worker was about to buy one of these for $40+. I casually mentioned that we could probably make one with a little bit of luck.

Lo and behold, here's the product. A Picatinny (Pica Tinny?) mount with a camera tripod mount threading on the other side.

I took two thingiverse things, mashed them together, resized a few hundred times (why do I suck at blender so much?) and here we are.

The sharpest angle is 50 degrees. It will print without supports just fine (print it like the sliced photo shows.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

25%~50%

Filament: AMZ3D PLA Lime Green

Notes:

Be careful out there.