5.6M/17' Antenna Telescoping whip support

I created this model in Fusion. I wanted to make it to fit the basic trucker style antenna mount. I have it wrapping around the base structure then I made the hole to where the bottom fits in the hex screw base mount as well as the wider insulator washer. all of the holes should be lined up but you may need to trim depending on your printers variances. 

This was made with the 5.6m/17ft antenna whip using the small m10 to 3/8x24 adapter at the base to change the thread to the standard trucker mount stud.

After assembly of the main structure, all that is needed is a harbor freight tent spike, or equivalent to mount to the back to be able to set this into the ground and deploy! if you get the harbor freight one, you will need to sand down the upper edge on the model side to make clearance for the top of the spike. 

I printed this using one with PETG and another ABS and I had no issues with my setup, as always yours may vary. This has been a great addition to my kit and I wanted to share with anyone who can use. Enjoy!