DREMEL Accessory Rugged Box

I created this box for my DREMEL accessory as a compact organizer that can be handy along.

If you noticed the top and bottom, its because I have used a carbon fiber textured build plate, though you can use your preferred build plates according to your 3D printer settings. 

================================================================================

Below are the parameters of per plate for your reference of the print profile:

Plate 1 - Top Lid:
Filament = Bambu Lab PETG-HF
Nozzle = 0.4mm
Layer height = 0.16mm High Quality
Wall loops = 2
Sparse infill density = 20%
Sparse infill pattern = Gyroid

Plate 2 - Base:
Filament = Bambu Lab PETG-HF
Nozzle = 0.4mm
Layer height = 0.16mm High Quality
Wall loops = 2
Sparse infill density = 20%
Sparse infill pattern = Gyroid

Plate 3 - Seal:
Filament = Bambu Lab TPU 95A-HF
Nozzle = 0.4mm
Layer height = 0.16mm High Quality
Wall loops = 2
Sparse infill density = 100%
Sparse infill pattern = Rectilinear

Plate 4 - Latch:
Filament = Bambu Lab PETG-HF
Nozzle = 0.4mm
Layer height = 0.16mm High Quality
Wall loops = 4
Sparse infill density = 20%
Sparse infill pattern = Rectilinear
Brim width = 5mm

================================================================================