QIDI Q2 LID RISER

How do you get access to the STEP files? The 'Files' section includes only STLs.

I like it. Fits perfectly.

Printed in black ABS (3 walls/15% infill/5 layers/0.2mm), as I wanted this machine to look factory/utilitarian.

I did think I wanted it taller, but it does clear the feeder tube and stops it bending over.

Haven't bothered with the foam inserts or even the lid clips yet.

I would like to possibly go a little taller and incorporate a PTFE tube mount/entrance, so as to do away with the ridiculous rubber tube filament guide on this machine.

Thanks very much for making this design available.

I like this riser because it's simple and clean, and you can just use the lid as usual. I don't need extra vents etc.

Is there any chance you could just stretch it out to be a bit taller, like 50-60mm? It would be much appreciated.

I got this to print laying flat on the bed in ABS. 0.24 layer, 3 walls, 15% infill. Only setting change was to heat the chamber to 60C, and I let it cool fully before opening the door.

Dead flat. Never got this big an ABS print to do it before.

Jeden Tag im Einsatz, danke!

Any plans for a shelf on top? Really like the clean design of this. Looking for a shelf type system for this type of riser with sliding glass/no vents.

Nice design! Easy to print and mount.

Very tight fit. Pinted in eSUN ASA+

Fit really well (ABS printed)

Great fit riser. Havent added any sealing material or screws, not sure if its even needed. Printed on Q2.

I printed it in Voxel PETG Galaxy. Very sparkly. Turned out good.

Gedruckt auf Qidi Q2 - Top Ergänzung, danke!

Printed easily in gray ASA.
Very good. I glued the pieces together with super glue.