Autodarts Electronics Case V1 + V2

These are two different versions of an electronics case for Autodarts systems. They are intended for use with an activ cooling solution for the pi (like this) and feature protection against rogue darts on the lids ventilation slots. For connecting of the LED strip a terminal block is handy. Both are optimized for use with a Karella sound isolation, but can be directly fitted against a surround. The parts differ between the versions, please read carefully below and use the corresponding files. No supports are requiered, the lids should be printed face down!

V1 - Slim bottom mount

Only works when space for USB connections is available above case! (like Karella lifted mount in the pictures or in use with surround, if you're unsure about your setup choose V2!)

This only houses a Raspberry Pi, a 12/24V to 5V-5A converter and a switch. It fits best on setups, where one camera arm is placed directly on top of the 20 (refer to pictures).

BOM

• Raspberry Pi 4 / 5
• 24/12V to 5V5A converter (like this: https://www.amazon.de/Hailege-DC-DC-Leistungsregler-Leistungsumwandlungsmodul-Einstellbar/dp/B0DRCSM7D1?)
• 8pcs of M3x6mm cap head screws
• 8pcs of M3 threaded inserts (Ruthex)
• Two countersunk head screws (should fit your wall) / strong double-sided tape
• A toggle switch (like this: https://www.amazon.de/QWORK-Kippschalter-Position-Arduino-MTS102/dp/B0B56S4F1X/ref=asc_df_B0B56S4F1X?)
• A 12V 5A power supply with screw-in counterpart (like this: https://www.amazon.de/Stromversorgung-Steckernetzteil-Netzadapter-Lichtstreifen-CCTV-Kamera/dp/B0BRPXSGHP?)
• Some wires and a soldering iron

V2 - Sturdy side mount

The side mounted case looks cleaner on optimal orientated setups (refer to pictures) and encloses a Raspberry Pi, a 12/24V to 5V-5A converter, a 12V relais and a switch.

• Raspberry Pi 4 / 5
• 24/12V to 5V5A converter (like this: https://www.amazon.de/Hailege-DC-DC-Leistungsregler-Leistungsumwandlungsmodul-Einstellbar/dp/B0DRCSM7D1?)
• 8pcs of M3x6mm cap head screws
• 8pcs of M3 threaded inserts (Ruthex)
• Two countersunk head screws (should fit your wall) / strong double-sided tape
• A toggle switch (like this: https://www.amazon.de/QWORK-Kippschalter-Position-Arduino-MTS102/dp/B0B56S4F1X/ref=asc_df_B0B56S4F1X?)
• A 12V 5A power supply with screw-in counterpart (like this: https://www.amazon.de/Stromversorgung-Steckernetzteil-Netzadapter-Lichtstreifen-CCTV-Kamera/dp/B0BRPXSGHP?)
• A 12V relais (like this: https://www.amazon.de/heschen-Relais-jqc-3-250-VAC-Terminals/dp/B07459YLH3/ref=sr_1_4?)
• Some wires and a soldering iron