Filter adapter to let the water into the tank under a softer angle (20°). The bend allows for the filter to go under water. (in the picture we are still filling the tank to make a better picture opf the piece. In the end it was under water)
Measure for tube diameter can be found in the pictures.
Either print in standing on the 19 mm diameter side without supports or print it on the 21 mm side with supports for the small overhang.
For water-tightness I recommend printing in resin. It is possible to print with filament as well.
Clean and cure intensively to avoid aquatic life intoxication when using resin.
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
No
Supports:
Yes
Resolution:
0.03 mm
Infill:
N/A
Filament: Anycubic Resin
Category: OtherThe author marked this model as their own original creation. Imported from Thingiverse.