Holder for Kobo Aura One eBook-Reader

The new eBook-Reader Kobo Aura One has an incredible wide screen but because of it's therefore wide case it is nearly impossible for people with normal hands to hold this reader with only one hand without getting cramps.

This holder let you convenient hold the reader with one hand.

I attached two different files for the holder depending if you want to hold the reader with your left or right hand. They are only mirrored. Additionally there is a combined Version for left and Right Hand Holding available.

Print one holder and two clips.

Print Settings

Printer:

FIashForge Dreamer

Rafts: 

No

Supports:

Yes

Resolution: 

0.20mm

Infill:

100%

Notes:

Support is only needed as a small wall underneath the hooks holding the reader (see attached picture). Don't generate supports into the slots holding the clips. A well calibrated printer can bridge the first closing layer over the slots and within the clips without problems.
Print with 100% infill for better stability.

Post-Printing

If your printer is well calibrated there is no sanding, filing or glue necessary to attach the clips to the holder. They will fit tight to the holders slots. You can use some careful hits to drive the clip into the slot.

You need a piece of hook-and-loop tape or adjustable slipknot-band to fix the holder on your hand. Pull it not too tight. It must only prevent the tipping of the reader.

Category: Gadgets