Plant Support

My pandan tumbled three times during the last time due to its weak trunk. Every time it was destroying its flower pot.

So I designed a support to further hold it in balance.

The corners are designed for a "greenmotion plant pot 40cm x 40cm".

Print two bows, eight tube ends and four corners.

Edit 2021/04/09: Printable bolt and circlip added to save metallic bolts and nuts. Print 8 bolts and 8 circlips.

Print Settings

Printer:

FIashForge Dreamer

Rafts: 

No

Supports:

Yes

Resolution: 

0.25mm

Infill:

40%

Filament:

PETG clear green

Notes:

Additional you need some plastic tubes with 14mm outer diameter, 2 bolts M6x30 and four bolts M6x40 with washers and nuts.
The assemble is to see in the pictures.

The corners needs a bit support below the begin of the upper edge. All other parts can be printed in the given orientation without support.

Category: Household Supplies