Clips for (halfround) LED-strips

I found an old LED-Strip which I wanted to use for the box my PrusaMini sits in. The clips are very simple, print laying down (I tried it standing up, but it just takes much longer and the others are by far string enough), and can be attached with double-sided-tape. I also did a version with a wider base for more glueing surface, as especially in the bends the glue of the small clips was not strong enough.
Note that the clips are intended for the “halfround”-LED-strips, maybe you can scale them if yours is of a different size. it is easy to clip them onto the strip but relatively hard to remove it again, you can however slide them around on the LED-strip if neccessary.

Printing worked well at 0.15mm height or even variable layer height.