I needed a place for my small 12v Bosch vacuum. Its a great little machine for tidying up my desk after cleaning out all those supports. A good buy if you are already invested in the 12v Bosch universe.
https://www.bosch-professional.com/dk/da/products/gas-12v-06019E3000
So I designed this minimal wall mount that just fits through the grip. I made it hollow to minimize material usage, and even though its caries weight on the layers as opposed to along layers, it is plenty strong even with batteries.
I also designed it this way as I wanted to play with the Fusion360 "sketch from an imported drawing", and I started with just a rough pencil outline of the inner grip.
It hangs fairly loose but grips fine and not too tight and is in no danger of falling off.
I printed it with ABS with a 0.6 nozzle with 0.4 layer height. I also added an exstra outer vertical layer just in case, but with the 0.6 nozzle it is not really needed.
Category: Tool Holders & BoxesThe author marked this model as their own original creation. Imported from Thingiverse.