iOttie Auto Sense Z Fold Compatible Arm

Practice project for my new calipers.

Measured the left half of the clamp on the iOttie Auto Sense mount and extended it to fit a Galaxy Z Fold 3 while keeping the right side over the wireless charging coil.

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Infill:

20

Notes:

Recommend printing it in a heat-resistant material as PLA will likely melt in the summer in hotter climates. My test print warped when the car was sitting under the late August sun.

I suggest printing with supports to make the surface of the arm flat to avoid it catching, when it goes in and out. But if you are confident in your printer, you can print it diagonally to minimize support material.

Category: Mobile Phone