Cube Bike cable stop, CUBE Frame Plug Cube cable guide, Gear cable guide

The frame plug for CUBE mountain bikes that guides the gear shifter cabled through the frame, i made this because the originals were quite flimsy. i found a model but when you downloaded it you needed to pay :(.

So i made my own.

I printed it with PETG-CF on 0.2mm layer height. 95% infill 2mm outer shell.

You can use the original screw and nut , you need to take the nut out , put it on the screw backwards and push it in to the hex shaped hole(see photo) , it should be tight or the nut will fall out. then assemble it all before putting it in the frame. Tighten the screw all the way up until it pulls the nut right up , then loosen it off so the top part becomes loose and you can put it into the fram and tighten it all up.

If you use this then i would appreciate a like , if you share it please give credit,

If you want to print it and sell it then i expect you to donate a percentage of your profits to chaity.

Good luck